Pictorial: HOW TO CLIP IN YOUR ATÁSI HAIR EXTENSIONS

How to clip in your 100% virgin Remy hair Atási clip in extensions.


Purchased a set of of Atási luxury virgin Remy hair clip in hair extensions but you've never installed clip ins before or just need a quick spruce up on how to install your clip in extensions, read below

These instructions will teach you how to SECURELY install your FULL 12 piece set 100% virgin Remy Atási Clip in hair extensions. Including your free bonus "tester" piece.

The tools you will need:
* Your set of 100% virgin Remy Atási clip-in hair extensions and your free bonus "tester" piece.
* Soft paddle brush
* Medium tooth comb
* Tiny hair rubber bands
* Several Hair clips or hair ties
* Mirror

Estimated installation time:
15-45 mins
Time varies per person
As with trying anything new, Your first few times may take longer until you get the hang of things.


We recommend practicing opening and closing your clips several times prior to installation to get the hang of how the clips work.


Step 1: Open up all the clips and all pieces of your extensions then Lay out your extensions, or "wefts," on a flat surface, grouping together like sizes.



Step 2: Start off by brushing your own hair thoroughly using a soft paddle brush to get rid of any tangles. Separate a straight thin section of hair with your finger or a comb at the nape of your neck and clip the rest of your hair away by using a hair clip.





Step 3: Take a 3 clip weft. Brush it out Starting from the bottom and work your way up the weft, using a soft paddle brush.







Step 4: Use small hair elastics to create not too tight sections of hair the same distance apart as atleast two of the extension clips. We recommend placing the rubber bands to accompany the left and the right clips, a rubber band section can be used for the middle clip if you please.

The rubber bands will prevent the clips from slipping off of your hair. Keep them in your hair the entire time you're wearing the extensions.

Be sure to leave a little bit of your own hair out on the sides of the rubber band sections, only a small rubber band section is needed.








Step 5: Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, then find the centre of your head and start by clipping (pushing the clips to close) the middle clip into the roots of your hair (in between the rubber band and your scalp). Then do the left and right clips. Make sure to clip as close as possible to your roots.





Step six: Part another section of hair a little less than half an inch up from the last section and tie/clip the rest of your hair back up.



Step 7: REPEAT STEP 4




Step 8: Grab another 3 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, then find the centre of your head and start by clipping (pushing the clips to close) the middle clip into the roots of your hair (in between the rubber band and your scalp). Then do the left and right clips. Make sure the clip is as close as possible to your roots.


Step 9: Part another section of hair a little less than half an inch up from the last section and tie/clip the rest of your hair back up.


Step 10: REPEAT STEP 4


Step 11: Grab the last 3 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, then find the centre of your head and start by clipping (pushing the clips to close) the middle clip into the roots of your hair (in between the rubber band and your scalp). Then do the left and right clips. Make sure to clip as close as possible to your the roots.




Step 12: Part another section of hair a little less then half an inch up from the last section and tie/clip the rest of your hair back up.






Step 13: REPEAT STEP 4





Step 14: Grab a 4 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, then find the centre of your head and start by clipping (pushing the clips to close) the middle clip into the roots of your hair (in between the rubber band and your scalp). Then do the left and right clips. Make sure to clip as close as possible to your roots.



If you parted your hair on the side, create the next section toward the side with the most hair — not directly in the middle of your head.

If you parted your hair in the center, you can continue placing the wefts at the center of your head.


Step 15: Part another section of hair a little less then half an inch up from the last section and tie/clip the rest of your hair back up.


Step 16: REPEAT STEP 4


Step 17: Grab the second 4 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, then find the centre of your head and start by clipping (pushing the clips to close) the middle clip into the roots of your hair (in between the rubber band and your scalp). Then do the left and right clips. Make sure to clip as close as possible to your roots.




If you have a side part, Create the next section of hair on the side of the head with more hair.

If you have a middle part create the next section on either sides



Step 18: *You may have to angle this clip depending on the shape of your head. * Part a section of hair about half an inch up from the beginning of your sideburns and tie/clip the rest of your hair back up.


Step 19: REPEAT STEP 4


Step 20: Grab a 2 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, start clipping (pushing the clips to close) the left or right clip first into the roots of your hair (in between the rubber band and your scalp). Then close the second clip. Make sure to clip as close as possible to your roots. You may have to angle this clip depending on the shape of your head.




Step 21: *You may have to angle this clip depending on the shape of your head.* Part another section of hair a little less then half an inch up from the last section and tie/clip the rest of your hair back up.


Step 22: REPEAT STEP 4



Step 23: Grab another 2 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, start clipping (pushing the clips to close) the left or right clip first into the roots of your hair (in between the rubber band and your scalp). Then close the second clip. Make sure to clip as close as possible to your roots. You may have to angle this clip depending on the shape of your head.




Step 24: *You may have to angle this clip depending on the shape of your head* Part another section of hair a little less then half an inch up from the last section and tie/clip the rest of your hair back up.


Step 25: REPEAT STEP 4


Step 26: Grab the third 2 clip weft and Hold the clip weft on top of the rubber band portions against your part to get a feel of how you will position the weft, start clipping (pushing the clips to close) the left or right clip first into the roots of your hair (in between the rubber band and your scalp). Then close the second clip. Make sure to clip as close as possible to your roots. You may have to angle this clip depending on the shape of your head.



If you parted your hair on the side repeat this process once more with a fourth 2 clip weft on the side with more hair.

If you are doing a middle part you may now move on to the other side of your head.


Step 26: *You may have to angle this clip depending on the shape of your head* Part a section of hair about half an inch up from the beginning of your sideburns and tie/clip the rest of your hair back up.

Step 27: REPEAT STEP 4


Step 28: Repeat the same process you did on the other side of your head, then lay the rest of your hair on top of your extensions to cover the wefts then WAAALAAAH, you may now style as you please.

*the two one clip wefts may be used to add more volume at the top of your head, closer to your part, to close in the gap if your hair is a little on the thinner side so that way your hair extensions can blend better and not be visible or for more volume in general if your natural hair volume is medium to thick **


Atási's 12 piece set: With a bonus free tester piece included, 100% virgin Remy Clip-in hair extensions were custom designed and tested on multiple hair types, hair lengths, and head sizes to ensure that our FULL set has more than an adequate amount needed for your hair extensions to look as glam as you are. We understand some ladies may like a less fuller look, if this is you, or you're a girl that likes a different look depending on the occasion...we totally understand because while some occasions scream for a full on diva glam other occasions call for a more subtle glam, you can choose to not use a clip or two per hair weft size or use the Full set to accustom your desired look, the choices can be endless.